ZOO MED LABORATORIES, INC. ZOO MED- TC-23- TURTLE CLEAN 20- DELUXE TURTLE FILTER- UP TO 20 GALLONS

Availability:

Out of stock

oo Med's TurtleClean 20 provides sufficient filtration for turtle tanks with up to 20 gallons of water. Mount vertically in a corner or horizontally for shallow tanks. Easy open door to clean filter cartridges without removing main filter from water. Highly efficient filter using only 7.5 Watts!

INSTRUCTIONS
Use Instructions: 1. Remove contents from box and inspect to make sure there are no missing parts. Connect the spray bar to the outflow arm. If you intend to have your filter positioned horizontally in your tank, you may put the elbow attachment on the spray bar before connecting it to the outflow arm Included are optional attachments that can be used in substitute of the spray bar to aide in aeration for your pet when the filter is mounted vertically; you may connect them at this time if preferred.2. Position the filter in an ideal location in your tank for adequate water circulation. Make sure to clean the glass surface thoroughly from algae or water deposits. Firmly press the filter in place, ensuring that the filter is fully submersed.3. The flow can be adjusted by rotating the round knob on the outlet tube to achieve your desired flow rate. During initial setup, adjust the outflow valve to its highest setting to purge air from the filter. When there is no longer air coming out of the spray bar, you may adjust the valve towards the min or max indicator as necessary.

SAFETY
Safety Warnings: To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment. For each of the following situations, do not attempt repairs by yourself; return the appliance to an authorized service facility for service or discard the appliance:1. If the appliance falls into the water, DON’T reach for it! First unplug it and then retrieve it. If electrical components of the appliance get wet, unplug the appliance immediately.2. Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.3. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or has been dropped or damaged in any manner.4. To avoid the possibility of the appliance plug or receptacle getting wet, position tank/aquarium stand and tank to one side of a wall-mounted receptacle to prevent water from dripping onto the receptacle or plug. A “drip loop”, should be arranged by the user for each cord connecting an aquariumappliance to a receptacle. The “drip loop” is that part of the cord below the level of the receptacle, or the connector if an extension cord is used, to prevent water from traveling along the cord and coming in contact with the receptacle. If the plug or receptacle does get wet, DON’T unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the appliance. Then, unplug and examine for presence of water in the receptacle.5. Close supervision is necessary when any appliance is used by or near children.6. To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp bulbs, and the like.7. Always unplug an appliance from an outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.8. Do not use an appliance for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition. Do not install or store the appliance where it will be exposed to the weather or to temperatures below freezing.9. For indoor use only, for aquarium/vivarium use only.10. Make sure an appliance mounted on a tank is securely installed before operating it.11. Read and observe all the important notices on the appliance.12. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.

Warranty Description: 1 Year Warranty